de Nic_Bv » 30 Sep 2008, 20:25
SETTING THE CLOCK AND DATE ON THE AUDIO UNIT
All units, except the 2050, the 5000C, the 6000CD with centrally located on/off and volume control, and Sony CD/6CD, have a built in facility that will receive RDS data for a current time and date display.
When first switched on, a series of bars may be displayed until the signal is received. In all cases, the time derived from the
signal is exact and in most units it cannot be altered. Some units, however, do allow you to set the time manually. On certain models, where possible,adjustments are made as follows:
• Press and hold the MENU button for approximately two seconds until the display changes.
• Press the MENU button repeatedly until a ‘CLK-MAN’ or ‘RDS TIME OFF’ display appears.
• Use the SEEK buttons to select ‘CLK-AUTO’ or ‘RDS TIME ON’.
Note: With ‘CLK-AUTO’ or ‘RDS TIME ON’ selected, the time will be set automatically via the RDS function if an RDS signal is available. In this case you will not find a time display to set the time manually. If you observe after setting ‘RDS TIME’ to ‘ON’, that the clock is not set properly, then the radio station selected does not support RDS clock setting.
In this case, either select another radio station which transmits a time signal or set the clock manually.
Note: If any of these features are not available in your unit, the relevant menu options will not be displayed.
5000C and 6000CD with centrally located on/off and volume control
Changing the date and time
• Press the CLOCK button to display the date and time.
Note: If you do not press another button within 30 seconds of pressing the CLOCK button, the display will return to its previous setting.
• Use the SEEK buttons to select the date or time value that you wish to change. The selected value will flash in the display.
• Turn the volume control to change the selected date or time value.
• Use the SEEK buttons to select additional date or time values that you wish to change.
• Turn the volume control to change the selected date or time value.
• Press the CLOCK button to exit and save the new date and time.
Audio unit clock and date displays
Note: If you do not press the CLOCK button within 30 seconds of changing a date or time value, the display will exit and save the new values automatically.
Tip: Press and hold the CLOCK button for more than two seconds to automatically select the hour value for winter or summer time adjustment.
12/24 hour format
• Press the MENU button repeatedly until a 12/24 hour clock display appears.
• Use the SEEK button to select the setting required.
• Press the MENU button again to confirm the selection.
.
oare nu exista un buton de reset general?????
. Mutumesc tare mult pentru interes dar daca totusi mai aflati ceva spuneti si lui baiatu ca-s beat de cap. Multumescccccc!!!!!1